Sevenoaks Builders Merchants by Discount Builders Merchants, Northfleet

Timber for sheds and log stores in Sevenoaks

Round Sevenoaks a good share of the timber that leaves a merchant goes into the garden: a log store by the back door, a shed, a bike shelter, a lean-to against the garage. This guide covers the posts, sawn treated timber and sheet in the lists, the roof coverings that go on top, and the planning question that comes before any of it.

Sevenoaks Builders Merchants is the Sevenoaks delivery site of Discount Builders Merchants (KENT) LTD, the builders' merchant at Lower Road, Northfleet, DA11 9BB. There is one yard, and orders are placed on www.discountbm.co.uk.

Stacks of treated timber with stickers in the yard

Posts and sawn treated timber

Timber posts are listed at 75 x 75 mm and 100 x 100 mm, each in 2.4 m and 3 m lengths. Sawn treated timber is 47 mm thick, in depths from 47 mm to 225 mm and lengths from 3 m to 6 m, though not every depth comes in every length. There are heavier sections of 150 x 72 mm and 225 x 75 mm at 4.8 m. The shop files the sawn treated timber as C24, the structural grade.

CLS is listed too, but the shop sells it untreated, so keep it for dry work indoors.

Framing a shed

A shed is usually a framed wall on a level base: one upright for every 400 mm or 600 mm of wall, plus one, with a plate along the top and another along the bottom. Square the base first, because a frame built on a twisted base never closes up at the door.

Joist and rafter sizes come from span tables or a drawing, not from what looks about right. That matters more as the building gets bigger.

What a log store needs

A log store wants air more than shelter. It usually stands on posts set in the ground; the fencing guide on this site gives the post mix to allow and how much of a post to bury. Leave the front open, slat the back and ends with gaps between the boards, and let the roof overhang the front so rain drips clear of the stack. Keep the bottom row off the ground on bearers. Featheredge strips from the fencing aisle make the slats, and treated batten is listed in three sizes for lighter framing.

Sheet for roof decks and walls

OSB is listed at 11 mm and 18 mm, shuttering ply at 12 mm and 18 mm, and marine plywood at 12 mm and 18 mm. A sheet of 2440 x 1220 mm covers 2.98 square metres: work out the area, divide, and add about a tenth for cuts. OSB makes a deck under felt, but it is not a finished surface, so do not leave it open to the weather. For the walls of a shed, shiplap cladding is listed in two patterns.

Roof sheets and felt

The roofing aisle has galvanised roof sheets 660 mm wide and plastic ones 760 mm wide, each in 6 ft, 8 ft and 10 ft lengths. Sheets overlap along their edges, so each covers less than its full width; ask the yard for the cover width before counting. Green mineral shed felt comes in rolls of 1 m by 10 m, with a heavier green mineral felt in the same size.

Planning, stables and the lane

Most of the countryside round Sevenoaks, Otford, Kemsing and Westerham is green belt. Buildings on agricultural or green belt land often need planning permission, even small timber ones. A shed in the garden of a house is usually allowed within set limits. Check with Sevenoaks District Council before ordering.

A stable or field shelter is a designed building: its frame, lining and base come from whoever draws it, and this guide does not try to size one.

Sawn timber is listed up to 6 m long, and a gateway is not always where a load can be left. Tell the yard the longest length on the order, how wide the lane is, and where the load can be set down. Stack timber off the ground on bearers, and keep sheet flat and covered until it is used.

Rules of thumb

Working figures for planning an order. Check them against your drawings and the product you choose.
Lengths listed Posts 2.4 m and 3 m. Sawn treated timber from 3 m to 6 m. Batten 3.6 m.
Framed walls Uprights at 400 or 600 mm centres: one per 400 mm of run plus one, plus top and bottom plates.
Structural timber C24 for joists and rafters. Sizes come from the drawings or span tables, not by eye.
Sheet coverage A 2440 x 1220 mm sheet covers 2.98 square metres. Add about a tenth for cuts.
Shed felt A roll is 1 m x 10 m, or 10 square metres, before laps.
Roof sheets Galvanised 660 mm wide, plastic 760 mm wide, in 6 ft, 8 ft and 10 ft lengths. Allow for the side laps.

The shop has calculators that turn a measurement into a quantity.

Worked order: A 3.6 x 1.5 metre log store in Kemsing

Priced with the shop's prices today, last checked , and the yard's delivery charge to TN15. Amounts are ex VAT unless marked.
Product Quantity What it is for Cost
100mm x 100mm x 2.4mtr Timber Post Brown 6 at £10.99 Three posts along the front and three along the back, with about 600 mm of each in the ground. Cut the back three down to give the roof its fall £65.94
Postmix / Postcrete approx. 20kg 12 at £4.16 Two bags a post £49.92
100x47x3600mm Sawn Treated Timber (4"x2") 9 at £7.19 Two as plates along the front and back; four cut in half for 1.8 m rafters, seven needed at 600 mm centres; three as bearers under the logs. Sizes for a small store only: use a span table for anything larger £64.71
OSB board 2440x1220x18mm 3 at £22.99 Roof deck of 3.6 x 1.8 m, 6.5 m2: 2.2 sheets at 2.98 m2, plus a tenth £68.97
1E Green Mineral Shed Felt 1mtrx10mtr (10M2) 1 at £26.99 One 10 m2 roll covers the 6.5 m2 deck with the laps £26.99
6" Featheredge Strips 1.8mtr 32 at £1.49 Slatted back and ends, 1.5 m high, to let air through: one 150 mm board every 200 mm is eight a bay, for two bays across the back and one at each end £47.68
Goods £324.21
Delivery to TN15 £0.00
Delivered total ex VAT £324.21
Delivered total inc VAT £389.05

Not in this order: Screws, which are in the fixings aisle, nails for the felt, which the lists do not show, and anything laid under the bearers.

The quantities are a starting point for a job of this size. Put the same goods in a basket on www.discountbm.co.uk with your own postcode to see the figure for your order, or send the yard your list.

On the shop today

The products this guide talks about, from the shop's Timber & Sheet Material aisle. Prices last checked .

Prices are the shop's prices today. Stock and ordering are on www.discountbm.co.uk.

Timber and sheet materials delivered in Sevenoaks See all Timber & Sheet Material on the shop

Delivery to Sevenoaks

TN13, TN14, TN15, TN16

Free when the goods reach £41.66 ex VAT (£49.99 inc VAT).

A smaller order pays the difference up to that amount: goods of £25.00 ex VAT (£30.00 inc VAT) pay £16.66 ex VAT (£19.99 inc VAT) for delivery.

TN8

£150.00 ex VAT (£180.00 inc VAT) when the goods are under £200.00 ex VAT (£240.00 inc VAT).

£50.00 ex VAT (£60.00 inc VAT) when the goods reach £200.00 ex VAT (£240.00 inc VAT).

Free when the goods reach £420.00 ex VAT (£504.00 inc VAT).

RH8

Not on the delivery list yet. Ask the yard for a price.

Delivery charges by district · Contact the yard

More guides for Sevenoaks